Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateRheem Mini-Split Installation: The Sandy Springs Owner’s Guide
We install and replace Rheem mini-split systems and components throughout Sandy Springs, with most complete installation jobs running between $3,500 and $7,500 depending on the size of the system, the number of indoor heads, and how much electrical work the home needs. We commonly complete single-zone Rheem mini-split installations same-day when the equipment is on hand, and two-to-three-zone setups can take a day and a half once we’ve confirmed the exact Rheem model you’re working with. The typical call we get from a Sandy Springs homeowner starts the same way: a Rheem mini-split that worked fine last summer now blows warm air, freezes the coil, or makes a clicking sound from the outdoor unit that wasn’t there before.
Which Rheem Models This Applies To
Rheem mini-splits fall into a few distinct series, and the installation approach changes with each. The Rheem Classic series includes single-zone systems in 9,000 to 24,000 BTU capacities, and those are the units we install most often in Sandy Springs sunrooms, garage conversions, and upstairs bedrooms that never quite cool down. The Rheem Select and Rheem Plus series step up in efficiency and include multi-zone outdoor condensers that can drive two to four indoor heads from one outdoor unit. Here’s a compatibility gotcha most homeowners don’t know: Rheem indoor heads are not universally interchangeable across series, even when the BTU rating matches. The wiring harness, flare fitting sizes, and communication protocol differ between Classic and Plus series, which means a replacement indoor head has to match the outdoor condenser’s series, not just its capacity. Before we order anything, we confirm the model number printed on the side of the outdoor unit and the connector style on the indoor head, then match OEM or a quality aftermarket equivalent that meets Rheem’s line-set diameter spec. That spec matters more than most people think: Rheem mini-splits typically use 1/4-inch by 3/8-inch or 1/4-inch by 1/2-inch line sets depending on capacity, and getting that wrong creates pressure imbalances that shorten compressor life.
Styles & brands we work with
Signs Your Rheem Mini-Split Installation Is Failing
- Warm air or no cooling at all. This usually points to refrigerant loss through a flare fitting that’s worked loose over time, or a failing inverter board on the outdoor unit. Sandy Springs summers expose both problems fast.
- The indoor unit freezes up or drips water onto the floor. A frozen coil often means low refrigerant or a clogged condensate drain line, and the water damage to wood floors happens faster than you’d expect. We protect floors with drop cloths before opening any unit inside the home.
- The outdoor unit makes a clicking or buzzing sound but the fan doesn’t spin. On Rheem units, this often points to a failed start capacitor or a compressor contactor that’s worn out after years of Georgia heat and humidity cycling.
- One zone works, another doesn’t. On multi-zone Rheem systems, a failing expansion valve or a kinked line set on one branch can shut down a single indoor head while the rest of the system runs fine.
- Error codes flashing on the indoor unit display. Rheem mini-splits use two-digit error codes, and a unit that’s throwing a communication error usually has a wiring fault or a main control board on its way out.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Rheem Mini-Split Installation Prices in Sandy Springs
- Single-zone Rheem mini-split installation: $3,500 – $5,200 installed
- Dual-zone Rheem mini-split installation: $4,800 – $6,800 installed
- Tri-zone Rheem mini-split installation: $5,900 – $7,500 installed
- Replacement indoor head only (existing system): $1,100 – $1,900 installed
- Replacement outdoor condenser only (existing line set): $1,800 – $3,200 installed
These are installed prices, meaning the unit, the electrical work, the line set, the mounting hardware, and the labor are all included in the written price before we start. What moves the number is mostly the electrical situation: older Sandy Springs homes in Riverside and along the Chattahoochee sometimes have panels at capacity, and running a new dedicated circuit adds to the job. We also factor in whether the line set can be routed invisibly or needs to run along an exterior wall where we’ll sleeve it. Every Rheem mini-split installation we do is backed by our 365-Day Done Right Promise. If it’s not right, we make it right. No runarounds.
DIY or Call Us?
We’ll be direct with you. A Rheem mini-split installation is not a handyman job, and it’s not a safe weekend project. These systems use R-410A refrigerant under high pressure, require a vacuum pump to purge the line set before release, and connect to 240-volt wiring. Doing it wrong damages the compressor, voids the Rheem warranty, and can put you face-to-face with a live electrical circuit. What you can safely do is check the air filter on the indoor head, clear debris away from the outdoor unit, and confirm that no furniture or curtains are blocking airflow to the indoor unit. Those are the three things that account for a surprising share of poor performance calls. Everything past that, including the installation itself, is work we’re trained and equipped to do. Luis Serrano learned the trade at Los Angeles Trade-Technical College and has put in nearly two decades of hands-on HVAC work across the Southeast, including plenty of Rheem mini-splits in Sandy Springs where older wiring and tight crawlspaces demand extra care. Tell me what the house is doing, and we’ll figure out the rest from there. Call us at (229) 490-2049 for a free estimate.
FAQs
A properly installed Rheem mini-split in Sandy Springs typically lasts 15 to 20 years, though Georgia’s heat and humidity mean the outdoor condenser works harder here than in milder climates, and units that shade the north or east side of the house tend to outlast ones baking in full sun. Call (229) 490-2049 if you want us to look at where yours is installed and what we’d expect from it.
Yes, in most cases we can repair it. A failed capacitor, a clogged drain line, a leaking flare fitting, or a bad thermistor are all repairable, usually between $150 and $650. When the compressor itself has failed or the coil is leaking in multiple places, replacement is typically the better financial call, and we’ll give you a written price for both options so you can decide without pressure.
A single-zone Rheem mini-split installation usually takes 4 to 6 hours from start to finish, including electrical, mounting, line set routing, and the system vacuum and leak test. Multi-zone systems take a full day to a day and a half. We’ll tell you the exact timeline after we see the home.
We keep common Rheem mini-split service parts on the truck, including capacitors, contactors, drain line components, flare fittings, and a selection of indoor head units. For full system installations, we order the exact Rheem model that matches your needs and have it delivered to the jobsite before the install date. Meadowsweet Heating and Air Sandy Springs also services and stocks parts for Carrier, Trane, and Lennox equipment. Call (229) 490-2049 and a live person will answer, day or night.
Written by Luis Serrano, Owner, Meadowsweet Heating and Air Sandy Springs at Meadowsweet Heating and Air Sandy Springs, serving Sandy Springs and nearby areas.